Step 1

For best results, avoid using this product in direct sunlight.

Step 2

Start by rinsing your vehicle from top to bottom to remove any loose soils or contaminants.

TO USE AS A BUCKET WASH:

Add 60-90 ml of PRO Pure Wash to a 19 liters bucket. Fill bucket using a strong stream of water to create a thick foam. Wash your vehicle from top to bottom, then rinse thoroughly and towel dry.

TO USE AS A FOAM SPRAY:

Mix 60 ml of PRO Pure Wash with approximately 414 ml of warm water and mix well. Apply foam to one 2’ x 2’ panel of your car and use a microfiber wash mitt to agitate stains and stubborn soils. Rinse thoroughly and towel dry. Continue washing your vehicle, one panel at a time, starting from the roof of your car and working your way down.

TO USE AS A CLAY LUBRICANT:

Mix 60 ml of PRO Pure Wash with approximately 414 ml of warm water and mix well. Apply foam to your car from top to bottom. Wipe the clay over the clear coat in light, back-and-forth passes, one panel at a time. Rinse your mitt regularly in a bucket of clean water. Continue wiping clay mitt over the clear coat until you have decontaminated the entire clear coat. Rinse your vehicle thoroughly and towel dry.

TO THE MAX WAX™ : HAND APPLICATION

Step 1

Wash your vehicle and rinse thoroughly. Clay and polish if needed to remove embedded dirt, contaminants, scratches, & swirl marks. Use Hybrid Solutions Pro 1 & Done Compound Correct & Finish™ to remove paint imperfections before applying wax.

Step 2

Apply 3 dime sized drops to an applicator pad and spread evenly over a 2’ x 2’ section using an overlapping circular motion.

Step 3

Wait 2-3 minutes to allow product to dry and haze.

Step 4

Fold a fresh microfiber towel and gently wipe excess product from the car’s surface using light, back-and-forth motions.

Step 5

Continue working in 2’ x 2’ sections until you have covered the entire surface of your car.

Step 6

To remove streaks or remaining product use a damp microfiber towel and finish by wiping with a soft dry microfiber towel.

TO THE MAX WAX™ : MACHINE APPLICATION

Step 1

Wash your vehicle and rinse thoroughly. Clay and polish if needed to remove embedded dirt, contaminants, scratches, & swirl marks. Use Hybrid Solutions Pro 1 & Done Compound Correct & Finish™ to remove paint imperfections before applying wax.

Step 2

Apply 4 dime-sized drops evenly spaced onto a soft foam buffing pad. Apply to a 2’ x 2’ section and slowly spread the product over the surface at a low setting. Do not over apply high active formula. As the applicator pad or soft foam buffing pad gets saturated, less product is needed per section.

Step 3

Wait 2-3 minutes to allow product to dry and haze.

Step 4

Fold a fresh microfiber towel and gently wipe excess product from the car’s surface using light, back-and-forth motions.

Step 5

Continue working in 2’ x 2’ sections until you have covered the entire surface of your car.

Step 6

To remove streaks or remaining product use a damp microfiber towel and finish by wiping with a soft dry microfiber towel.

TO THE MAX WAX™ : MAINTENANCE APPLICATIONS

Allow paint to cure for 24 hours before washing. Apply an additional coat as needed or use Hybrid Solutions Pro Flex Wax™, with easy maintenance options, to maintain professional performance and guarantee a continual web of protection year-round.